
17
4.1 AUXILIARY BATTERY
The wireless beltpack has a battery holder to place an alkaline
battery, Ni-MH battery 2500 mA/h or lithium battery of AA size, which
gives us a range of 3/4/5 hours respectively with the main battery
discharged.
Be very careful, do not insert the battery in reverse polarity, as it
may break the circuitry of the wireless beltpack.
Always remember to remove the empty battery.
4.2 RESET BUTTON
The unit has a RESET button near the auxiliary battery holder in order to reset the
unit in case of malfunction
NOTE ON ENVIRONMENTAL PROTECTION:
After the implementation of the European Directive 2002/96/EU in the
national legal system, the following applies:
Electrical and electronic devices may not be disposed of with
domestic waste. Consumers are obliged by law to return electrical an
electronic devices at the end of their service lives to the public
collecting points set up for this purpose or point of sale. Details to this
are defined by the national law of the respective country.
This symbol on the product, the instruction manual or the package
indicates that a product is subject to this regulations.
By recycling, reusing the materials or other forms of utilising old devices, you protecting our
environment.
5. SPECIAL RECOMMENDATIONS
Don’t place the unit in close proximity to metallic surfaces and/or other electronic
equipment in order to avoid interferences.
In case of lose of range, reorient your body position to face up the base unit position.
Take special attention to the placement of the base station when trying to reach all
the possible placements of the beltpacks specially when concrete walls or other absorbing
materials are in between.
In order to have the units ready to operate, it is a good practice to make a full charge
of all the units every two month.
6. TROUBLESHOOTING GUIDE
WHEN: POSSIBLE CAUSES AND SOLUTIONS
1) Abnormal low range. a) With the beltpacks on, switch off the base station, wait for 30
seconds and then switch on to reorganize links.
2) Beltpack switch on but
does not link with the base
station.
a) Beltpack is not registered. If the base station have free registers,
register it normally.
b) If you have more than a system it is possible that this beltpack
WBP-212 WIRELESS DUAL CHANNEL MANAGER
Commentaires sur ces manuels