Altair WBP-200 Spécifications télécharger pdf (Page 11)

WBP-200 SINGLE CHANNEL WIRELESS BELTPACK.

Make sure that the fuse is the right one for the selected voltage:

FUSE (230V. 50-60 Hz) FUSE (115V. 50-60 Hz)

T0,5A. T1A.

NOTE: The fuseholder provide a place for spare fuse.

CAUTION: Always make sure upon changing the fuse, that this is the adequate for the selected

mains voltage (T1A for 115V and T0,5A for 230V).

CONNECTING TO THE MAINS

The connection of the battery charger ALTAIR WBPC-200 power supply to the

mains takes place by a standard cord included in the box.

Make sure that the beltpack are disconnected from the battery charger.

Insert the female I.E.C. connector of the tripolar cable into the unit power supply

male connector, placed at the rear panel.

Insert the male connector of the tripolar cable into the mains plug.

In that moment the charge LEDs indicators will light in green colour,

indicating that the unit is turned on.

CAUTION: Make sure that the mains voltage is the correct as well as their fuse is the adequate.

BELTPACK BATTERY CHARGE

The battery charger ALTAIR WBPC-200 has four connectors to allow the charge up to four

wireless beltpacks at the same time.

Take any of the battery charger connector and insert it in a wireless beltpack connector. If the

battery charger is connected, the connector associated LED of the battery charger will change from

green to orange, indicating that the wireless beltpack batteries are charging.

If the beltpack is turned off, the LEDs battery bargraph will begin to blink from down to up

indicating the charger connection. If the beltpack is turned on, will not be changes of these LEDs

unless the key ON/OFF is pressed briefly.

After three hours time, the charger sets to trickle (maintenance) mode and can be left alone in

the charger, and the LED associated to the charger connector turn intermittent between green and

orange. For a full charge, it is recommended a 2 hours minimum charging in this state.

If a problem appears in one of the connectors, and the consumption increases, the battery

charger ALTAIR WBPC-200 will protect itself, and the LED associated to this connector will turn to red

colour.

1 2 ... 6 7 8 9 10 11 12 13

Pas de commentaire

Altair WBP-200 Spécifications Page 11