8
If the microphone phantom power is enabled, this icon: appears near to the
microphone icon .
When using electret type mics, MIC level must be set to around 5 steps higher than
minimum position as general recommendation. Set also the SIDE TONE setting accordingly.
The state of the microphone phantom power, it is stored in the unit.
FACTORY PRESET:
OFF (Dynamic mic.)
3.6.3 MICROPHONE EXTRA GAIN
The wireless beltpack has an additional 6 dB
microphone gain, so if it is necessary an additional micro-
phone gain, we can activate the microphone extra gain. This
extra gain can be enabled/disabled via the appropriate menu, or directly without accessing the
beltpack menu, pressing the MIC ON/OFF switch, and at the same time the upper panel
VOLUME DOWN switch.
If the microphone
appears near to the microphone
The state of the
FACTORY PRESET:
OFF (Microphone extra gain disabled).
3.6.4 SIDETONE GAIN ADJUSTMENT
The sidetone gain adjustment allows attenuating or amplifying
the own mic signal that we listen in our headphones. The sidetone
gain can be adjust with the appropriate menu, or directly without
accessing the beltpack menu, pressing the SELECT (BUZZER) switch and at the
same time the front panel VOLUME switches (UP to increase the gain or
DOWN to decrease the gain).
The SIDETONE GAIN, it is stored in the unit. Press again to switch on the buzzer.
FACTORY PRESET:
7.
3.6.5 VIBRATOR ON/OFF
This beltpack vibrator can be enabled/disabled via the
appropriate menu, or directly without accessing the beltpack menu,
pressing the MIC ON/OFF switch, and at the same time the SELECT (BUZZER)
switch (changing the vibrator state, if it is on, turn to off mode and if the
vibrator it is turned off, turn to on mode).
3.6.6 HEADSET BEEP REGULATION
Each time you depressed a key, the beltpack emits a beep onto
the headsets to confirm keystroke operation. Depending of the
ambient noise or personal preferences you can adjust or cancel out
that beeps.
This headset beep volume can be changed via the
appropriate menu, or directly without accessing the beltpack menu, pressing at the
same time both UP and DOWN front panel VOLUME switches to select between 3
possible adjustments: HIGH, LOW, OFF.
This headset beep volume adjustment will remain on memory.
FACTORY PRESET:
LOW
WBP-210 SINGLE CHANNEL WIRELESS BELTPACK
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels